R&S provides and installs automation accessories for residential garage doors, steel overhead doors, commercial sectional doors, sheet doors, sliding doors as well as aluminum rolling grilles and residential or commercial gates.

Miller Edge
Linear Controls
PowerMaster Control Stations - Interior | Exterior
Viking Gate Operator Accessories

Miller Edge

top

Linear Controls

Delta3
The popular Delta 3 line offers 256 codes and a 310 MHz frequency, which is ideal for most sites.

MegaCode
The MegaCode line offers a 318 MHz frequency and adds the security of over 1,000,000 codes, each sequentially preset by the factory to all but eliminate any possibility of duplication.

MultiCode
The Multi-Code brand is preferred among so many installers of gate operators and systems, garage door operators, and commercial access control systems.

For more information on the Delta3, MegaCode and MultiCode lines please see Linear's site.

top

Power Master Control Stations

Interior

Surface Mounted

3PBS

2PBS

1PBS

Flush Mounted

3BF

1KF

1KFS

top

Exterior

top

Ceiling Pull Switches

top

Viking Gate Operator Accessories

Magnetic Lock System
Viking Magnetic Lock provides the versatility to have added security in access control applications by operating at 12 VDC and 24 VDC. The holding force of 1300 LBS ensures the holding retention of the locking action when the electromagnet is energized. The special material used in the armature plate prevents excessive magnetic memory ensuring the prompt release of the locking action.

Viking Hinges
The oil impregnated material, and the grease-port in the Viking Hinges guarantee constant lubrication to the ball bearing and the hinge-pin holding the gate weight. The Viking Hinge has a capacity up to 3000 lbs. (per pair of hinges) thanks to the heat-treated stainless steel hinge-pin.

Viking Custom Pipe Stand
Upon the request of Viking customers; Viking is offering a pipe-stand to provide a solution where the Viking Slide Gate Operators can be installed above ground level. This optional item enables the installer to increase the flexibility of installation where natural near ground obstacles prevent the normal typical installation.
The pipe stands is designed to take a 3.00" OD pipe (not provided) and it is manufactured out of aluminum to prevent rust problems.

Power Box
The Viking Power Box presents a good alternative where the Viking Gate Operator is not near electricity (120 VAC or 220 VAC). The Viking Power Box provides means to run low Voltage Wires as power supply Instead of trenching, piping and running wires from far distances to the Viking Gate Operator to provide the high voltage. It also eliminates the need to get an approval from the city or regulatory agencies (in some cities) since it only runs low voltage. The Viking Power Box ensures continuous operation of the Viking Gate Operator allowing the 100% duty cycle of operation.

Loop Rack
The Viking Loop Rack adds value to a Viking Gate Operator Installation since it will interface up to three plug-in loop detectors eliminating the extra wiring, and bulky normal size loop detectors. The troubleshooting and installation time gets reduced since only two connectors are required to have a complete installation with three loop detectors.

Solar Panel
Viking Access Systems carries solar panels with high solar cell efficiency and outstanding energy output in low light conditions. The nominal voltage for the solar output is rated at 12VDC. The use of two solar panels (Solar Panels connected in series) is required for a 24VDC solar system such as Viking Gate Operators. Consult with Viking and we will advise about the number of cycles, the accessories recommended and the number of days of operation in case of cloudy days based on the installation location.

Gear Head Heater
Viking Gate Operators normally work in cold climates all the way down to -4F. Nevertheless when a Viking Gate Operator is required to operate on temperatures below 0F we normally recommend the use of a Viking Heater. The heater is a self adhesive blanket (with a thermostat integrated) that wraps around the motor-gear-head ensuring the proper viscosity on the lubricant inside the gear-head therefore ensuring the operation of the Viking Gate Operator in very cold climates.

top